[Mikhail]

Hi,

Check this answer.

[Mikhail]

A scheme file is located inside the project. You should check folders up starting from the scheme folder until find *.rsproj file.

• This reply was modified 2 years, 10 months ago by Mikhail.

[Mikhail]

Hello,
The main sequence would be:
1. After a scheme is open, detect the project folder, and load the channel table.
2. Extend property grid to be able to select channels by implementing an editor. See this link for example.

[Mikhail]

Hello,

Currently, Scheme Editor is taken from Rapid SCADA 5. So it’s difficult to integrate it with a project of Rapid SCADA 6.

Do you need to display channels that exist in the project inside Scheme Editor?

[Mikhail]

Hi,
You need a channel of the Output type. Command code must match with the module. If you provide screenshots of the settings and sending command, I could check.

[Mikhail]

Hi,

You can run *.bat or *.sh from formulas. For example:

Process.Start(@"C:\1.bat");

[Mikhail]

Also possible

dateTime = DateTimeOffset.FromUnixTimeSeconds((long)unixTimeStamp).ToUniversalTime();

[Mikhail]

Hi,

Thank you for the update.
Note that DrvOpcUa.View.xml affects user interface. DrvOpcUa.Logic.xml affects how the driver works.

[Mikhail]

Hi,

@emhatek, what version of Rapid SCADA do you use?

[Mikhail]

Hi,

But when I set command as Send Command instead of Send Command Now, it does its job.

Could you compare the messages in ScadaServer.log in the both cases and provide screenshots?

[Mikhail]

Hello,

First of all, I would log some message if data.type == "report" to check whether that section is executed.

[Mikhail]

Hello,

You could try installing .NET6 manually as written here.

[Mikhail]

Hi,

When a window is opened in a new tab, a browser decides whether to use a tab or separate window. You should check browser settings.

When a window is opened in a popup, it is specified by SCADA. To change it, you can edit JavaScript files, however, it’s not recommended.

[Mikhail]

You can send a string command like

cmd=ExportArchive
startDT=2022-12-23 10:00:00
endDT=2022-12-23 11:00:00

to export historical data.
When DB Export module receives such command, it executes the historical data queries that exist in the module configuration.

[Mikhail]

Hello,

In such situation, using JS is the right method. If it doesn’t work, provide more info.

[Author]

Posts