Declaring Commands

Forum Home Forums Understanding the Software Declaring Commands

Tagged: 

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #6757
    Avatarggallareta
    Participant

    Hello, I have a doubt from what I have read and seen on the videos, if it is required to declare also an input channel when you declare an output channel to send commands (or values)to OPC variables (for example). I understand that you have to link them together for the command (or value) to be sent to the destination (OPC in my case).

    Thanks in advance

    #6758
    MikhailMikhail
    Moderator

    To send a command you need only an output channel.
    You should create an input channel to get a measurement to it.

    However, for a relay it’s useful to create both, input and output channels. Input channel to get a relay state. And output channel to change it.

    #6763
    Avatarggallareta
    Participant

    I’ve tried and worked fine

    Thanks and Regards

Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.