arduino

[franperales1]

Hi. I have successfully installed rapid scada in windows 10. I can make an application to connect with mega arduino. what libraries should I add to arduino to communicate with rapid scada.
There is someone in the forum who has something about it.
There is a tutorial to create a new project based on arduino.
Thanks in advance.
a greeting

[Mikhail]

Hi,
In simple case you can implement it without libraries: https://github.com/2mik/arduino-2mik

[jirex27]

Hi there,
I am developing an automated building system and I am using RAPIDSCADA for monitoring purposes. Can you help me through with it? Like I have two PIR sensors which light two LEDs respectively according to the signal and similarly a LM35 sensor to start a relay. How do I go along with it? And how do i upload MODBUS RTU to the arduino?

[Mikhail]

I can help you with Rapid SCADA. I am not a master of Arduino. I heard there are existing implementations of Modbus for Arduino.

[jirex27]

Can you help me or provide information about the implementations?

[jirex27]

I’m familiar with the arduino programming. I need help with the communication between RAPIDSCADA and Arduino.

[Mikhail]

If Arduino is programmed to support Modbus, you can connect it to Rapid SCADA. See http://doc.rapidscada.net/content/en/use-cases/modbus-protocol.html

[manraj]

Hi there!

I am building a pipeline project using RAPID SCADA.I would need to connect some pressure sensors to an arduino and the arduino would need to be connected to the SCADA cloud monitoring.Could you suggest me the typical arduino board and its sensors that is compatible to RAPID SCADA.

[Mikhail]

Hi,
If your Arduino supports Modbus, it can be connected to Rapid SCADA. See the boards here https://www.arduino.cc/ They are all good

[manraj]

Can this support Modbus because it is integrated with TCP.Does that means it can support Modbus.

https://store.arduino.cc/usa/arduino-uno-wifi

[Mikhail]

Likely. Depends on the sketch you upload to it.

[AHI 633]

Hi every body
I have a problem with Rapid SCADA configuration , software was installed in windows 10 but communicator does not popup when trying to configure communication with device …
urgent help is appreciated
thank you all

[Mikhail]

Hi,
Duplicated here

[Pieter]

For anyone that finds this. I use mgsmodbus for arduino. Works great aswell.

[Pieter]

Download from here

[Author]

Posts