Sending PC time to peripheral device

Forum Home Forums Development and Integration Sending PC time to peripheral device

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • #3188
    Marko
    Participant

    Hello,

    Is it possible to send PC time (Hour and minute) to some peripheral device(send time every 60 seconds or more)?

    #3192
    Mikhail
    Moderator

    Hi,
    Yes. You need:
    – Automatic Control module
    – Input channel with a formula that changes its value every 60 seconds. This is a trigger for sending command.
    – Output channel that automatically calculates command value.

    #3196
    Marko
    Participant

    I follow steps for installation Automatic Control module. But when i try to open properties for configuration of module i get this error (picture below). Also if i want to save configuration same problem occur again so i am not able to save any configuration in module

    • This reply was modified 6 years, 1 month ago by Marko.
    #3197
    Marko
    Participant

    Picture

    • This reply was modified 6 years, 1 month ago by Marko.
    • This reply was modified 6 years, 1 month ago by Marko.
    • This reply was modified 6 years, 1 month ago by Marko.
    #3202
    Marko
    Participant

    I fix the problem. I saw solution in AutoControll load problem topic.

    #3206
    Mikhail
    Moderator

    OK 🙂

Viewing 6 posts - 1 through 6 (of 6 total)
  • You must be logged in to reply to this topic.