Conecction wirh DNP3

[RapidVZ]

Hello,
How to connect a device that only supports DNP3?
Could a Modbus-DNP3 gateway be an option? What else is there?

[manjey73]

Either a gateway or an OPC server.
There is no native DNP3 driver in Rapid Scada.

[RapidVZ]

And is there a guide to do it with the opc server

[manjey73]

Well, first you need to find an OPC server for DNP3. Depending on the OS, it can be either OPC DA or OPC UA.

Which OS are you installing Rapid Scada on?

[RapidVZ]

The operating system is Windows 11 x64 and the equipment is Toshiba TB-R1000.

[manjey73]

Toshiba TB 1000 – the Internet says it’s a hard drive.
It is not so important, since you use Windows for Scada, then both OPC DA and OPC UA servers for the DNP3 protocol will suit you. But I would look to the future and look specifically for an OPC UA server for this protocol. As they say, look for the pocket (the price that suits you)

[manjey73]

Are you looking for the cheapest option to read DNP3?
Perhaps you should really look for another Scada solution where DNP3 is supported?

[RapidVZ]

https://drive.google.com/file/d/18AX-5VUHqc8CAvjOWB43jFGLUQ-Ycuhg/view?usp=drivesdk

This manual is the tbr 1000

[manjey73]

There is no access

[Mikhail]

How to connect a device that only supports DNP3?
Could a Modbus-DNP3 gateway be an option? What else is there?

Hello,

Use a 3rd party OPC server or a hardware gateway.

[Author]

Posts