Try to integrate with IED using DNP3 Protocol Forum Home › Forums › Development and Integration › Try to integrate with IED using DNP3 Protocol Tagged: DNP3 This topic contains 2 replies, has 2 voices, and was last updated by Mikhail 10 months, 3 weeks ago. Viewing 3 posts - 1 through 3 (of 3 total) Author Posts August 22, 2018 at 1:01 pm #4158 bobchou2Participant Hi there, just start use rapid scada, great project, thanks! But there is a problem, I saw rapid scada not support DNP3? Is there anyway to connect DNP3 device and rapid scada or do you guys have plan to add dnp3 support in future? thanks a lot! August 22, 2018 at 1:38 pm #4159 bobchou2Participant IED means Intelligent Electronic Device, thanks! August 22, 2018 at 3:26 pm #4160 MikhailModerator Hi, To connect a DNP3 device you should use an OPC server that supports this protocol. We would develop a native DNP3 driver for Rapid SCADA if some company sponsored such development. Author Posts Viewing 3 posts - 1 through 3 (of 3 total) You must be logged in to reply to this topic.