KNX Driver

Forum Home › Forums › Development and Integration › KNX Driver

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • November 26, 2019 at 2:35 am #6078
    msaleh
    Participant

    I managed, in the past, to develop advanced software for KNX integration. I am planning to write driver which enable RAPID SCADA to read and write KNX bus devices. I need more details documentation about writing the driver. Where I can find hat?? any information or comment is welcome

    November 26, 2019 at 3:14 pm #6080
    Mikhail
    Moderator

    Read this as an introduction.
    Then use the existing drivers as templates.

    November 29, 2019 at 6:52 am #6107
    msaleh
    Participant

    HI thank youfor the info

    I have managed to combile the dll files and load them to rapidscada, however the dll is only shown in the driver and shoing as device type.

    please help me with that

    November 29, 2019 at 7:37 am #6108
    manjey73
    Participant

    You would screenshots have shown that and as you have broke a ?

    November 29, 2019 at 3:19 pm #6115
    Mikhail
    Moderator

    Hi,
    Also check if the driver description is displayed well in Communicator.
    Screenshots needed.

  • Author
    Posts
Viewing 5 posts - 1 through 5 (of 5 total)
  • You must be logged in to reply to this topic.