Communication error and reconnection

Forum Home › Forums › Communicating with Devices › Modbus › Communication error and reconnection

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • #18298
    Hcinarli
    Participant

    The connection to my Modbus devices can sometimes drop, or the devices may restart. When they restart, I want the SCADA system to continue reading from where it left off. I’ve tried various configurations myself but haven’t been able to resolve the issue. I’ve attached a screenshot of the settings. What else can I try?
    Thank you in advance.

    #18299
    Mikhail
    Moderator

    Hi,
    A configuration should ensure that the connection is restored after a connection failure. Please provide links to screenshots of the Communicator settings and communication line log.

    #18300
    Hcinarli
    Participant
    #18302
    Hcinarli
    Participant

    I’m not sure if I sent the correct log, but there are settings in the screenshots—you can check them.

    #18305
    Mikhail
    Moderator

    Please don’t post so large logs. It was deleted. Upload it to a file hosting and post link here.

    #18306
    Mikhail
    Moderator

    Try set the Disconnect on error checkbox.

Viewing 6 posts - 1 through 6 (of 6 total)
  • You must be logged in to reply to this topic.