Change "Signal" number

[ali_amiri]

Dear all,

I have two Modbus device with static IP
I made two communication line for them in the SCADA-Communicator.
First device’s values is shown in the Webstation but other device is not shown.
I assign signals 1 till 30 to first device and 2001-2030 to second one.
I understand I can not change signal in the modbus template for second devices.
How can I solve this problem?

Best regards,

[manjey73]

Just have devices with the same templates should be different KP in the database

[ali_amiri]

Hi Manjey73,
I don’t understand.Please explain more.
please look at these pictures:

[ali_amiri]

https://www.dropbox.com/s/twp9oumw9d8k6hd/Capture01.JPG?dl=0
https://www.dropbox.com/s/s5tmmnhl7i8wef5/Capture02.JPG?dl=0
https://www.dropbox.com/s/w1gl1h8qwv7v65a/Capture03.JPG?dl=0
https://www.dropbox.com/s/p3xcggw7zowyj3r/Capture04.JPG?dl=0
https://www.dropbox.com/s/hes3ubdoux4pvmh/Capture05.JPG?dl=0
https://www.dropbox.com/s/6hazlpb1k02yfkf/Capture06.JPG?dl=0

[manjey73]

Our database create different KP for the same type of devices.
Call Number list for each device as well in the database.
When you specify the device Bound and the KP number the Call Number is taken from the database (priority when the flag Bound)
Tab Request Sequence, create a few queries and specify the settings for each device. The binding channels will occur at the number KP, and the signal numbers

https://s3.postimg.org/wy7mr4xpv/Modbus_1.png

[Mikhail]

Set the same signals for device 62 as the signals for device 61. It’s OK. The input channel numbers are different.

[ali_amiri]

Hi Mikhail,

can you explain more?
I could not solve the problem.
If you need more information please tell me.

[ali_amiri]

Now I receive both device data correctly in the “scada-communicator”.
but I can not show devices value on the “webstation”
only one of devices value is shown.

[Mikhail]

I need screenshots of configuration and working to understand what settings you did and find out the cause of the issue.

[Author]

Posts