After the custom unit is wrong, it cannot be modified

Forum Home Forums Runtime Bugs After the custom unit is wrong, it cannot be modified

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • #9885
    grhsc
    Participant

    When I importing custom units, I reversed the name and sign.
    Then I referenced it in the project’s input channel, and since I was using the import-export, I didn’t find this error.
    I didn’t find this error until the project was downloaded and run.
    Finally, I found the wrong unit in the scheme, I hope to fix the error

    I swapped the name and sign order, re-downloaded, could not correct this error.
    I even deleted the input channels and units, completely re-created, the error is still there and cannot be modified.

    • This topic was modified 7 months ago by grhsc.
    #9889
    Mikhail
    Moderator

    Please provide screenshots of the error and a sequence of steps to reproduce the error.

    May be you should refresh the Input channels table before using new units.

    #9896
    grhsc
    Participant

    Maybe I misunderstood name and sign, I did it again and it seems to be normal.
    The sign field is the unit displayed in the scheme, right?

    thank you

    #9906
    Mikhail
    Moderator

    > The sign field is the unit displayed in the scheme, right?
    That’s right.

Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.