- This topic has 38 replies, 6 voices, and was last updated 2 weeks, 6 days ago by
.
-
Posts
-
Hello Han Hoang,
Nice to talk with you I also would like to use gmail or other email account to get the notification. Can you share your steps or procedures or do you need to purchase any plug in so that it is successful now?
THanks for your help and support.
Dear Vitorlam,
I have not been purchased any plugin. You have to do wall steps in instruction so that you can get results.
The best regards
Han HoangDear Mr.Mikhail,
I have been structed a problem in Automatic module. I don’t understand where is wrong, the Automatic module sends an email with wrong alert. For example, the automatic module will be send alert an with value > 100 mA when the Over Leakage Current is up > 100 mA but in my case it is unnormal. You can see it via screenshots bellowing:
https://ibb.co/cNxcNH1
The Triger parameters is bellowing
https://ibb.co/XC7QqB2
Where is wrong? How to fix it?
Thanks and best regards
Han HoangHello,
It sends the current channel value. Likely, the value became smaller when the module repeats sending email according to the trigger options.Dear Mr.Mikhail,
Thank you for your reply.
Can we resolve this problem by configuring a automatic module? That means Automatic sends only a high value.
Thanks a lot
Han HoangHello,
I checked the source code: {CnlVal} variable should show a value that caused the trigger to fire. Could you create a simple project based on HelloWorld to reproduce the issue using data generated by simulator?
Note: the issue should be also occurred in Rapid SCADA 6, because any new changes are made in the 6th version.
In your screenshot, “On normalization” checkbox is set. Likely, be the message was sent when value became normal.
- You must be logged in to reply to this topic.