Send command

[Mikhail]

OK

[hethongscada62]

Dear Mr.Mikhail,
Related to this topic” Send command” , can i ask You a question:
Will 2 relays be controlled via only 1 Button?.
That’s mean can the command send 1 value to more than 2 input when the Button clicks?
Thanks and best regards
Han Hoang

[Mikhail]

Hello,

You need Automatic Control Module to send 2 commands by 1 click.
You send the 1st command as usual. A command trigger reacts on the 1st command and sends the 2nd command.

[Mikhail]

Do you mean that 2 relays are 2 different devices?

[hethongscada62]

Dear Mr.Mikhail,
– The Automatic Control module is using on my project now.
– Yes, the 2 relays are 2 different devices. That’s mean only 1 Button can turn On or Off 2 devices at one.
So how to configure the Automatic Control module?
Thanks

[Mikhail]

Hello,

So how to configure the Automatic Control module?

You should add a new trigger of the command type that reacts on the 1st command. Then add a 2nd command below the created trigger.

[gabeirinhas]

Good afternoon, is there any way to send a command from the telegram chat, to activate a signal?

I am able to send notifications with a trigger but I wanted to know if it is possible to send commands in the opposite direction.

Thank you.

[Mikhail]

Hello,
Currently, the Telegram driver doesn’t support receiving commands. It is a good idea for the future improvements.

[gabeirinhas]

thanks

[SGG]

Hello,
If the time duration to poll a device is 5seconds, and I send a command, rapid scada waits till the device is polled before executing that command.

Is it possible for rapid scada to suspend/cancel the polling, execute the command then continue/restart the device polling?

Regards.

[manjey73]

The command is sent immediately, there is a checkbox in the survey settings for polling immediately after the command

[Mikhail]

Hello,

If the time duration to poll a device is 5seconds

Request timeout cannot be interrupted. Use smaller timeout if needed.

[SGG]

Thanks Mikhail, I will use shorter timeouts…thanks also to Manjey.

[redass]

Hello, I would like it to send the value immediately (without entering the command) when the button is clicked. This value is e.g. 111e. Does it need to be entered in the formula or is there a function somewhere?

[manjey73]

@redass
When using the mnemonic circuit, there is a “Send command immediately” mode, by default the command sends a value of 0, which can be changed by the output formula of the channel at your discretion.

[Author]

Posts