Numerical display is wrong

[leon]

hi

The single digit display cannot be 0.2.4.6~…..
Ten digits display normal

Is it where I set the error?
https://imgur.com/a/u5NoQ5W

[Mikhail]

The single digit display cannot be 0.2.4.6~…..
Ten digits display normal

Hi,
I don’t understand the question. Could you explain?

[leon]

hi
From PLC or SCADA Send the command (Decimal) 0.2.4.6.8~…
Scada shows 1.3.5.7.9~…
I hope that Scada is also showing 0.2.4.6.8~…
Is it related to formula?

[Mikhail]

Hi,

If you have a formula for an input channel, it affects. You didn’t provide a screenshot of the input channel, so I’m not sure.

[leon]

hi
I have not set the formula.
From the scada send command or from the plc send command,
Scada communication is normal.

But showing a problem through the input channel
I sent 0 show 1
I sent 1 is normal
I made 2 shows 3
I sent 3 is normal
I made 4 shows 5
and many more…
(Please refer to the picture above)

Sorry, I didn’t explain it very clearly.

• This reply was modified 5 years, 9 months ago by leon.
• This reply was modified 5 years, 9 months ago by leon.

[leon]

Input channel command type switching counter, formula is Cnl*200/65536 – 40

If Input channel command type real will overflow.

• This reply was modified 5 years, 9 months ago by leon.

[leon]

https://imgur.com/a/Qjz3ub5

[Mikhail]

You should change the type of the channels to Real.
Formula was needed for the ADAM input module. May be your module doesn’t need any formulas.

[Author]

Posts