Modbus addressing size Forum Home › Forums › Communicating with Devices › Modbus › Modbus addressing size This topic has 4 replies, 3 voices, and was last updated 8 years, 7 months ago by Mikhail. Viewing 5 posts - 1 through 5 (of 5 total) Author Posts September 5, 2015 at 10:59 am #406 ASAParticipant Hi the modbus addressing range appears to be 0 to 65536 is there anyway to make it to say 0 to 500000? if so how? ASA September 5, 2015 at 11:07 am #407 ASAParticipant oops my mistake please disregard my post as i am reading the addressing wrong on my devise………. ASA September 5, 2015 at 1:23 pm #408 MikhailModerator OK, no problem ) September 21, 2015 at 5:09 pm #540 Gabriel VellosoParticipant I am with the same error here, I am trying to communicate with a Schneider PLC, the address used in another driver is 400001, but I cant set this address in the comunicator? September 21, 2015 at 7:03 pm #541 MikhailModerator 400001 means that you should select Holding Registers (4x) data table and the 1st start element address. Author Posts Viewing 5 posts - 1 through 5 (of 5 total) You must be logged in to reply to this topic. Log In Username: Password: Keep me signed in Log In