andrusha

Forum Replies Created

Viewing 7 posts - 1 through 7 (of 7 total)
  • Author
    Posts
  • September 30, 2015 at 12:27 pm in reply to: Automatic Control Module #563
    andrusha
    Participant

    Как я могу обновить этот модуль, чтобы такая возможность появилась?

    • This reply was modified 8 years, 7 months ago by andrusha.
    September 22, 2015 at 5:34 am in reply to: Automatic Control Module #542
    andrusha
    Participant

    Rapid SCADA 4.5

    September 18, 2015 at 7:22 am in reply to: Write value in tag #504
    andrusha
    Participant

    Thank u , but i want to do this without web.

    September 18, 2015 at 6:03 am in reply to: Write value in tag #500
    andrusha
    Participant

    if i try to write in formula’s cell CmdVal = 3 i get error CS0200 from scada server thats mean Scada.Server.Svc.Calcengine for readonly. So how can i send command?

    September 18, 2015 at 5:20 am in reply to: Write value in tag #498
    andrusha
    Participant

    I thought that i can send commands using output channel.

    September 17, 2015 at 7:09 pm in reply to: Write value in tag #496
    andrusha
    Participant

    Oh,its working if i send command from Commands page. But can i do same action automatically, using formulas in Scada Administator for example? If its possible, how to do this operation.

    September 17, 2015 at 2:10 pm in reply to: Write value in tag #491
    andrusha
    Participant

    Yes , but i use in my work another opc server. OPC server is not my problem. My problem is writing value in to tag. Not reading.

    • This reply was modified 8 years, 7 months ago by andrusha.
  • Author
    Posts
Viewing 7 posts - 1 through 7 (of 7 total)