Singapore

Forum Replies Created

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • in reply to: New device drivers #10456
    Singapore
    Participant

    Hello, thank you very much for your answer. According to the steps provided by you, I can debug the DLL program normally. Thank you for your support.

    in reply to: New device drivers #10454
    Singapore
    Participant

    Hello, thank you very much for your reply. Can I understand that the newly developed driver DLL can not be debugged in the administrator application source code debugging mode, but can only create a new solution to debug the DLL separately or copy the DLL to the communicator installation directory? I wonder if there is any way to debug DLL in the administrator application source code debugging mode? Thank you very much for your support.

    in reply to: New device drivers #10448
    Singapore
    Participant

    I attached the DLL process of the new driver to scadacommsvc.exe in the debug directory, scadacommsvc Exe is registered as a service. However, the breakpoint in the DLL is invalid. The prompt: the breakpoint will not be hit at present, and no symbols have been loaded for the document。What are the detailed steps of using VisualStudio to debug the driver?

Viewing 3 posts - 1 through 3 (of 3 total)