weissclemens1990

Forum Replies Created

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • February 4, 2021 at 6:53 pm in reply to: Send command #8244
    weissclemens1990
    Participant

    Hi,

    Yes i need an extra flag Variable. How can I create this?

    February 3, 2021 at 10:19 pm in reply to: Send command #8240
    weissclemens1990
    Participant

    Hello,

    I Need a internal 1 Bit Memory for set on and off the Alarm Message. A internal coil. When a cool in the plc change d to zero then i will send an error SMS nur only when a internal Bit in rapidscada is on

    February 2, 2021 at 5:47 pm in reply to: Send command #8235
    weissclemens1990
    Participant

    No i want to send an SMS. This is Not the Problem. I would like to create a condition to set the Alarm off also when the Alarm channel is trigger. When the error is on and the channel x is on then i will send the SMS with auto command. When the Channel x ist 0 then Sending no sms

    February 2, 2021 at 1:16 pm in reply to: Send command #8232
    weissclemens1990
    Participant

    Hi,

    i would like to send alarm massage with auto command module. i would only send the command automatically when a Input channel in Rapid Scada is active. can i need input channel and output channel in Rapid scada only for rapidscada internal using?

    an Example:

    Pump1 have a Fault and send over automatic command module a Error message only when a Inputchannel in Rapidscada is activ. I need this to switch On/Off automatic alarm messages.

    Nice Regards from Austria

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)