Forum Replies Created
ok, i done as you suggest and now it’s work.
I install .NetFramework at first and then iis.
Yes, i try to remove all .Net framework 3.5 and 4.8 and iis setup on “Turn window on or off” then reinstall again. But problem still occur.
yes, it has this file on C:\SCADA\ScadaWeb\
i try as you suggest but problem still occur.
i try to uninstall/reinstall iis and select same as your link detail but can solve problem.
Problem was the same. When i open webstation, it will show error both scheme and table pages.
i check my iis and see that it use asp.net 4.8. i don’t know is this a problem for this? I try to run aspnet_regiis.exe -i and it show “This option is not supported on this version of the operating system.”. i use window 10.
Any suggest for this problem.
here is my selection when install iis.
now, i’ve problem with autologin,too.
before i add autologin to scadaweb folder, everything work fine.
after i add autologin to scadaweb folder and try to access website via address http://localhost/scada/login.aspx , i can pass login padge but it show error like this
and when i try to access website to be autologin like this http://localhost/scada/autologin.aspx , it show error like this
so, how can i solve this. please suggest.
i try to do as your mention. after that i found error occur on screen. it show message error to update scheme data and i see all graphic did not show value.
it’s look like graphic can not connect to database.
how can i solve it?July 2, 2019 at 11:01 am in reply to: All value reset to 0 when device lost communication #5652
i try to use this formula : Cnl > 0 ? Cnl : Val()
but the result is when i write to 0, input still show 1. and device connect normally.May 15, 2019 at 4:50 am in reply to: Problem with create function with more than 3 inputs. #5450
here is error from server.
2019-05-14 20:02:34 <DESKTOP-1CTUDRI><SYSTEM><ERR> Error compiling the source code of the formulas
Line 742, column 58; error cs1501: No overload for method ‘if2’ takes 2 arguments
See the file c:\SCADA\ScadaServer\Log\CalcEngine.cs with the source code
2019-05-14 20:02:34 <DESKTOP-1CTUDRI><SYSTEM><ERR> Normal program execution is impossible
i’m create function “if2” with 3 inputs and got this error.
and here is my function.
public if2(double in1,double in2,double in3)
if(in1==0 && in2==1)
in1 & in2 are input parameter from register via modbus and in3 is extra input that i create to database to get result from this function.
how can i solve it, please suggest.