battassini

Forum Replies Created

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • in reply to: Address Modbus RTU #5147
    Avatarbattassini
    Participant

    Dear.

    Below the hold register address in the I / O module that I use.
    Do I need to trigger a digital output D01?

    https://ibb.co/Xt7RW8B

    https://ibb.co/SxjmQs7

    in reply to: Programming #5146
    Avatarbattassini
    Participant

    Dear.

    For I use C# for writing formulas. The local is:

    https://ibb.co/fGHtBrY

    Once you have programmed the formula to use it just insert in output channel Formula:

    https://ibb.co/m5hTS6x

    Thanks

    in reply to: Address Modbus RTU #5142
    Avatarbattassini
    Participant

    Hello.

    Thanks for the answer but I already tried both binary and standart options and also tested sending 0 or 1.

    Thanks.

    in reply to: Programming #5139
    Avatarbattassini
    Participant

    Dear.

    For use formula c# first I programming formula in Administrator option Dictionaries – Formula.
    After I Used the created Formula in field Formula Output Channels in Administrator?

    Thanks.

    in reply to: Modbus TCP or RTU #5110
    Avatarbattassini
    Participant

    Please always I run application on the rapid Scada I have to execute all the steps of the video First RUN?

    And if I disconnect PC where it is running application and connect again I have to start everything manually?

    Thanks

    in reply to: Modbus TCP or RTU #5093
    Avatarbattassini
    Participant

    Dear.

    Thank you for your quick response.
    I have a problem.
    The Administrator is not opening when I run it? Not open?
    My windows 8.1.

    Thanks.

Viewing 6 posts - 1 through 6 (of 6 total)