scadarapid

Forum Replies Created

Viewing 4 posts - 46 through 49 (of 49 total)
  • Author
    Posts
  • in reply to: Can we use Scheme to change Input channel value #5311
    Avatarscadarapid
    Participant

    Normally, We use register from ModbusRTU to relate with input channel and output channel. If I do not have any register from ModbusRTU but I need to relate the value from Scada-Administration input channel and output channel.
    How can I do.

    Example I create an input channel number 1000 then, I want it to receive value from button on Web-station when I do not click the button the value of input channel = 0, if I click it the value input channel = 1, after that I will use this value of input channel to make relation something. It likes input enable button.

    I apologize,if my explanation is not good.

    Thank you so much.

    in reply to: Can we use Scheme to change Input channel value #5310
    Avatarscadarapid
    Participant

    Hi, Mikhail

    Can I make an toggle scheme to send data only 0 or 1 to the input channel,
    If I do not have any register and output channel.

    the input channel direct receive the value from toggle scheme. than I will use that value from input channel to make relations to another input channel.

    in reply to: how to use Dash Board and Chart Pro #5278
    Avatarscadarapid
    Participant

    Hi.
    I forgot to change configuration Web Application at Chart Plugin so, I change it from Chart to Chart Pro.
    It already work.

    Thank you so much.

    in reply to: Trial key Automatic Control Module #5237
    Avatarscadarapid
    Participant

    I have send my Computer Code and my email to Admin already.
    on 2019/03/28 Time 9:00 AM

    Thank you so much

Viewing 4 posts - 46 through 49 (of 49 total)